Design of Drill Jig and Milling Fixture for the Component Button Lock
Mahendra H S1, Hemaraju2, Siddartha D.E3
1Mahendra H S, Dept. of Mechanical Engg, BGS Institute of Technology, Adichunchanagiri University, B G Nagara, Karnataka, India.
2Dr. Hemaraju, Dept. of Mechanical Engg, BGS Institute of Technology, Adichunchanagiri University, B G Nagara, Karnataka, India.
3Mr. Siddartha D.E, Dept. of Mechanical Engg, Adhichunchangiri Institute of Technology, Chikkamagaluru , Karnataka, India.
Manuscript received on 25 June 2019 | Revised Manuscript received on 05 July 2019 | Manuscript published on 30 July 2019 | PP: 865-870 | Volume-8 Issue-9, July 2019 | Retrieval Number: I7755078919/19©BEIESP | DOI: 10.35940/ijitee.I7755.078919
Open Access | Ethics and Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: In the present study a milling fixture and drill jig was designed, developed for the component bracket for seat arrangement. As per the requirements of rigid and economic tool, the materials are selected for both Jig and Fixture. Standards of IS and BIS requirements for entire tool was followed in order to fulfill tooling requirements. A detailed modelling and detailing were done by CATIA v.15 modelling software. A complete procedure of fabrication was discussed and enumerated. Detailed costing and estimation were done and tabulated. Considering the perception and evaluation of tool design engineer it is concluded that the designed drill jig and milling fixture has good strength from design point of view and able to fulfill the requirements of tool and engineering department.
Keywords: Drill Jig, Milling Fixture, Clamp Plate.
Scope of the Article: Component-Based Software Engineering