Automatic Bar Bending Machine using Pneumatic System
R. Sasikala1, M. Rakshana2, T. Thinaa3, P. Thirupponvel4, D. Vasanth5
1Mrs.R.Sasikala*, Assistant Professor, Department of Electrical and Electronics Engineering Kongu Engineering College, Perundurai.
2M.Rakshana, Department of Electrical and Electronics Engineering Kongu Engineering College, Perundurai.
3T. Thinaa, Department of Electrical and Electronics Engineering Kongu Engineering College, Perundurai.
4P. Thirupponvel, Department of Electrical and Electronics Engineering Kongu Engineering College, Perundurai.
5D.Vasanth, Department of Electrical and Electronics Engineering Kongu Engineering College, Perundurai.
Manuscript received on February 10, 2020. | Revised Manuscript received on February 20, 2020. | Manuscript published on March 10, 2020. | PP: 1345-1348 | Volume-9 Issue-5, March 2020. | Retrieval Number: E2097039520/2020©BEIESP | DOI: 10.35940/ijitee.E2097.039520
Open Access | Ethics and Policies | Cite | Mendeley
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: The main intention of this project is to automate the bar bending process using pneumatic system to reduce the cost and enhance the productivity. Conventional Methodologies involve major labour work, layout setup, high cost etc. Hence to reduce labour cost, Automation is preferred. Existing hydraulic system are cost high enough, so to make cost effective, Pneumatic bar bending system is proposed here. Sample bar is taken about 8mm and pressurized with a compressor of about 25-30mm. Entire test setup size assembled is 2*2 square feet. This project discuss about the construction and process of pneumatic based bar bending system, also the associated practical implications during implementation.
Keywords: Piston, Bar Bending, Pneumatic Cylinder.
Scope of the Article: Machine Learning