Development of Combined Cutting Process using Water-Cooled Cutting Tool
Zotova V.A.1, Semakhin E.A.2, Permovsky A.A.3, Romanovskaya E.V.4, Andryashina N.S.5
1Zotova V.A. Minin Nizhny Novgorod State Pedagogical University
2Semakhin E.A. Minin Nizhny Novgorod State Pedagogical University
3Permovsky A.A. Minin Nizhny Novgorod State Pedagogical University
4Romanovskaya E.V. Minin Nizhny Novgorod State Pedagogical University
5Andryashina N.S. Minin Nizhny Novgorod State Pedagogical Universit
Manuscript received on December 16, 2019. | Revised Manuscript received on December 22, 2019. | Manuscript published on January 10, 2020. | PP: 329-332 | Volume-9 Issue-3, January 2020. | Retrieval Number: C8073019320/2020©BEIESP | DOI: 10.35940/ijitee.C8073.019320
Open Access | Ethics and Policies | Cite | Mendeley
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: Technological aspects of the process of turning shafts with heating of their surfaces to temperatures below recrystallization point and simultaneous improvement of the heat sink from the cutting zone, as well as increasing stability of the cutting edge of a tool. A constructive diagram of the tool device has been developed, which allows for high-performance machining with a given quality of the surfaces of parts from hard materials on lathe equipment.
Keywords: Cutting, Wear, Tool, Scheme, Method, Workpiece, Cutter, Detail, Material, Heating, Operation, heat.
Scope of the Article: Knowledge engineering tools and techniques