An Approach to Find the Stresses Induced in a Flat Belt during Half Rotation of a Driving Pulley
Shrikant A. Thote1, M. K. Sonpimple2, G. D. Mehta3
1Shrikant A. Thote, Department of Mechanical Engineering, RTM Nagpur University/ Priyadarshini College of Engg/ LTJSS, Nagpur, India.
2Prof. M. K. Sonpimple, Department of Mechanical Engineering, RTM Nagpur University/ Priyadarshini College of Engg/ LTJSS, Nagpur, India.
3Dr. G. D. Mehta, Department of Mechanical Engineering, RTM Nagpur University/ Priyadarshini College of Engg/ LTJSS, Nagpur, India.
Manuscript received on 07 February 2013 | Revised Manuscript received on 21 February 2013 | Manuscript Published on 28 February 2013 | PP: 1-4 | Volume-2 Issue-3, February 2013 | Retrieval Number: A0360112112/2013©BEIESP
Open Access | Editorial and Publishing Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: Flat belt drive are the working horses of industries which is also called as loop of flexible material and are used to connect to or more rotating shaft mechanically for massive amount of power transmission. The main purpose of this thesis is to reason out the concept of failure of the belt during continuous operation and to see the stress pattern during half revolution of a pulley in a belt of a belt drive.
Keywords: Belt Drive, Major & Minor Diameter of Pulley, Velocity ratio & Rated Power
Scope of the Article: Expert Approaches