Effect of Tool Overhang Length on Turning Operation Using Finite Element Model
B.Tulasiramarao1, P. Ramreddy2, K. Srinivas3, A.Raveendra4
1B. Tulasiramarao, Research Scholar, Jawaharlal Nehru Technological University, Hyderabad, Telangana, India.
2Dr. P. Ramreddy, Professor, Department of Mechanical Engineering, Jawaharlal Nehru Technological University, Hyderabad, Telangana, India.
3Dr. K. Srinivas, Professor, Department of Mechanical Engineering, R.V.R. & J.C. College of Engineering, Guntur, Andhra Pradesh, India.
3Dr. A. Raveendra Associat Professor, Department of Mechanical Engineering, Malla Reddy Engineering College, Secunderabad, India.
Manuscript received on 05 March 2019 | Revised Manuscript received on 12 March 2019 | Manuscript Published on 20 March 2019 | PP: 486-488 | Volume-8 Issue- 4S2 March 2019 | Retrieval Number: D1S0105028419/2019©BEIESP
Open Access | Editorial and Publishing Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open-access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: Turning accuracy and productivity rates become key determinants and both the accuracy and surface quality plays vital role. In this paper the cutting tool modeled with finet element model and for different tool overhanging lengths analytical modal has prepared. The modal and stiffness data of the tool are extracted from ANSYS software also the mode shapes were drawn. Tool overhang was selected as input and the influences of tool overhang on the stability of turning using finite element was obtained. The stability lobe diagrams corresponding to different tool overhangs different stiffness, tool frequencies and damping ratios were presented.
Keywords: Ansys Software, Finite Element Model Tool Over Hang Length and SLD.
Scope of the Article: Mechanical Maintenance