Home Automation using Thingspeak
Sai Vignesh Ramisetty1, Pavan Akkineni2, Obbu Goutham sai3, Pujith Sai P4
1Sai Vignesh Ramisetty, Department of Electronics and Communication Engineering, Vellore Institute of Technology, Vellore (Tamil Nadu), India.
2Pavan Akkineni, Department of Electronics and Communication Engineering, Vellore Institute of Technology, Vellore (Tamil Nadu), India.
3Obbu Goutham Sai, Department of Electronics and Communication Engineering, Vellore Institute of Technology, Vellore (Tamil Nadu), India.
4Pujith Sai, Department of Electronics and Communication Engineering, Vellore Institute of Technology, Vellore (Tamil Nadu), India.
Manuscript received on September 23, 2020. | Revised Manuscript received on November 03, 2020. | Manuscript published on November 10, 2021. | PP: 219-223 | Volume-10 Issue-1, November 2020 | Retrieval Number: 100.1/ijitee.A81711110120| DOI: 10.35940/ijitee.A8171.1110120
Open Access | Ethics and Policies | Cite | Mendeley
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: Nowadays automation of the house is one of the fast growing branches of IoT. Everyone is interested in automating their houses. So this automation is normally made using arduino, relay board, HC-05, and other sensors. So our aim is to demonstrate home automation using thingspeak both auto and manual. In this we are using both automatic and manual mdes. so that users can switch between these modes easily and can run the appliances. to know whether the status of ac or heater is changed after giving the command we are displaying this information in a web page, it keeps updating for every few seconds so that you can easily check whether the appliances are switched on or off.
Keywords: HC-05, and other sensors.
Scope of the Article: Network Performance; Protocols; Sensors