Estimation of Strength by Partially Replacing Fine Aggregate with Saw Dust
R. Chitra1, K. Sathish Kumar2, S. Thendral3
1R. Chitra, Department of Civil Engineering, Bharath Institute of Higher Education and Research, Chennai (Tamil Nadu), India.
2K. Sathish Kumar, Department of Civil Engineering, Bharath Institute of Higher Education and Research, Chennai (Tamil Nadu), India.
3S. Thendral, Department of Civil Engineering, Bharath Institute of Higher Education and Research, Chennai (Tamil Nadu), India.
Manuscript received on 12 October 2019 | Revised Manuscript received on 26 October 2019 | Manuscript Published on 26 December 2019 | PP: 1084-1086 | Volume-8 Issue-12S October 2019 | Retrieval Number: K129810812S19/2019©BEIESP | DOI: 10.35940/ijitee.K1298.10812S19
Open Access | Editorial and Publishing Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open-access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: This paper speaks to the aftereffects of the examination did from the utilization of considered residue to be incomplete swap for fine total in concrete. Saw dust is a side-effect of cutting penetrating or generally coming about because of the mechanical milling. In this fine total was supplanted by considered residue to be 0%,5%,10%,15% by weight for M-20 Mix. The solid 3D shapes were tried for compressive quality at 7 years old days and 28 days. The result got was contrasted and typical solid M-20 Mix. The result shows that compressive quality declines as the saw residue pecrcentage increases. Optimum supplanting of sand with saw dust was seen as 15%.
Keywords: Concrete, Saw Dust, Ordinary Portland Cement, Compressive Strength.
Scope of the Article: Concrete Structures