Optimisation of Cutting Parameters for Minimal Surface Roughness in Single Point Diamond Turning of TI6AL4VELI
Nitish Chandra1, Sukhdeep singh Dhami2
1Nitish Chandra, Present, Pursuing Master of Engineering (Manufacturing Technology) from NITTTR, Chandigarh.
2Dr. Sukhdeep Singh Dhami Professor and Head of the Department in Mechanical Engineering at the NITTTR, Chandigarh.
Manuscript received on September 15, 2019. | Revised Manuscript received on 24 September, 2019. | Manuscript published on October 10, 2019. | PP: 3222-3226 | Volume-8 Issue-12, October 2019. | Retrieval Number: L30661081219/2019©BEIESP | DOI: 10.35940/ijitee.L3066.1081219
Open Access | Ethics and Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: In this study the effect and optimisation of machining parameters on surface roughness in a facing operation of Ti6Al4VELI by single point diamond machining have been investigated. The experimental studies carried under varying cutting speeds, feed rates, different tool nose radius and depths of cut. The orthogonal array, signal-to-noise ratio (S / N) and variance analysis (ANOVA) were used to examine the performance characteristics of the Ti6Al4VELI alloy turning by using single-point diamond cutting tool. The influential factors on the surface roughness after machining are feed rate and cutting speed after the conclusions revealed. Whereas the feed rate had the most significant effect on tool life. Minimal surface roughness achieved after machining is in nano-level which is better than other conventional precision machining.
Keywords: Taguchi Method, Analysis of Variance (ANOVA), Ti6Al4VELI, Signal-to-noise (S/N) Ratio, Surface Roughness.
Scope of the Article: Frequency Selective Surface