Corona Discharge Properties Near Metal and Dielectric Surface
Dmitri L. Kirko
Dmitri L. Kirko, Department of Plasma Physics, National Research Nuclear University MEPhI, Moscow, Russia.
Manuscript received on December 14, 2019. | Revised Manuscript received on December 25, 2019. | Manuscript published on January 10, 2020. | PP: 3662-3665 | Volume-9 Issue-3, January 2020. | Retrieval Number: C9127019320/2020©BEIESP | DOI: 10.35940/ijitee.C9127.019320
Open Access | Ethics and Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: This following research of the properties of a coronary discharge has a serious impact on the study of metallurgy. There are a lot of cases of practical use of the corona discharge functions. An example is the creation of electrostatic precipitators for the purification of industrial gases from solid and liquid particles. Using the corona discharge method, for example, smoke is cleaned in the production of sulfuric acid, air in non-ferrous metal foundries and other harmful industries. Shape of the corona discharge made utilizing cone shaped and round and hollow terminals was examined. The most electrical characteristics of discharge of this type are decided. Corona discharges are characterized by weak currents within the extend of one microampere at voltages on the arrange of 10 kilovolts and adequately week gleam discharge. Electric fluctuations within the discharge current circuit within the extend 1 kHz-120 MHz are enlisted. To think about the oscillatory forms, there were used electric and attractive tests, signals from which were sent to the Tektronix TDS 2024B oscilloscope working within the frequency analyzer mode. The electrical tests were spoken to by metal poles 1-10 cm in length and 4-5 mm in diameter. As magnetic tests, there were used coils (diameter 2-4 mm, number of turns 70-140, wire thickness 0.1 mm) set in protective dielectric walled in areas. These tests were located at a separate of 0.5-1.0 m from the release. Possible waves in plasma are suggested to explain these oscillations.
Keywords: Corona Discharge, Electrodes, Electric Oscillation Processes, Metallography, Physics of Metals, Plasma Waves.
Scope of the Article: Metallurgy