Multi-Objective Flower Pollination Algorithm Based Controller for UPQC Including Hybrid Power Source
K. Hussain1, Puli Sridhar2
1K. Hussain*, Department of Electrical Engineering, Sharad Institute of Technology College of Engineering, Yadrav (Ichalkaranji), Kolhapur (Dist.), Maharashtra, India.
2Puli Sridhar, Department of Electrical and Electronics Engineering, TRR College of Engineering, Patancheru, Telangana, India.
Manuscript received on December 13, 2019. | Revised Manuscript received on December 22, 2019. | Manuscript published on January 10, 2020. | PP: 3493-3502 | Volume-9 Issue-3, January 2020. | Retrieval Number: C8433019320/2020©BEIESP | DOI: 10.35940/ijitee.C8433.019320
Open Access | Ethics and Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: This paper presents a new control method for Unified Power Quality Conditioner (UPQC) for effective management of the power-sharing and improvement of the quality of power. The voltage disturbances produced in the source side due to non-linear load conditions can be protected using the UPQC model. Flexible Alternating Current Transmission System (FACTS) devices were fed through a hybrid power generator that had the primary source, a Proton Exchange Membrane Fuel Cell (PEMFC) and a secondary source, a supercapacitor. In this paper, a multi-objective function (power factor, voltage sag, and the total harmonic distortion (THD)) with different control strategies have been considered. An optimization algorithm named Flower Pollination Algorithm (FPA) has used for optimizing Proportional Integral (PI) coefficients. A suitable fitness function has been developed for the FPA method and the simulation performed. The performance of the FPA method has been compared with three different algorithms, namely, particle swarm optimization algorithm (PSOA), Differential Evolution Algorithm (DEA), and Ant Colony Optimization Algorithm (ACOA). The result obtained shows the proposed FPA providing the best result compared to other methods.
Keywords: Multi Objective Function, Flower Pollination Algorithm, UPQC, Total Harmonic Distortion, Power Sharing.
Scope of the Article: Algorithm Engineering