Comparative Studies on Influence of Tool Geometry on Heat Generation in Friction Stir Welding Process
Pavan Kumar Thimmaraju1, G. Chandra Mohan Reddy2, Krishnaiah Arkanti3
1Pavan Kumar Thimmaraju*, Department of Mechanical Engineering, Osmania University, Hyderabad (Telangana), India.
2Dr. G.Chandra Mohan Reddy, Department of Mechanical Engineering, Chaitanya Bharathi Institute of Technology, Hyderabad (Telangana), India.
3Dr. Krishnaiah Arkanti, Department of Mechanical Engineering, Osmania University, Hyderabad (Telangana), India.
Manuscript received on 12 March 2022 | Revised Manuscript received on 21 March 2022 | Manuscript published on 30 April 2022. | PP: 1-5 | Volume-11 Issue-5, April 2022. | Retrieval Number: 100.1/ijitee.E98210411522 | DOI: 10.35940/ijitee.C9821.0411522
Open Access | Ethics and Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: Friction Stir (FS) welding offers a number of advantages over the conventional fusion welding process, and it is used to join aluminum alloys that are difficult to weld by fusion welding processes. It has compatibility to any alloy composition, and produces the welded joints by eliminating the defects with improved mechanical properties. The weld quality is mainly influenced by the heat generated and material flow pattern that takes place during the friction stir welding process which depends on the above mentioned parameters. The mechanical and micro structural properties are highly influenced by the heat generation and material flow patterns. The tool geometry plays a vital role in the heat generation and material flow. The aim of the research is to study the influence of tool geometry on heat generation and temperature during friction stir welding process. A comparative study has been done based on the results obtained from numerical analysis and experimentation. It was found that the dissimilar FS welded joints fabricated using hexagonal tool pin profile generates optimum heat generation and temperature required for formation of quality weld irrespective of other process parameter.
Keywords: Friction Stir Welding, Heat Generation, Tool Geometry, Thermography, Temperature.
Scope of the Article: Welding Technology